Zeno~SPARTA~ Posted May 1, 2022 Share Posted May 1, 2022 This is a work in progress and will be updated and or corrected Shut Door (Lctrl C works) LC right click Master Ignition Switch to BATT LC right Click APU Cover to open LC left click APU button to start APU, wait for ON to appear LC right click No 1 Engine Start (left engine), on left MFD when NG% > 20% Ralt Home to advance left throttle to Idle. Wait for NG% to stabilise around 67% LC right click No 2 Engine Start (right engine), on left MFD when NG% > 20% Rshift Home to advance left throttle to Idle. Wait for NG% to stabilise around 67% LC Advance throttles to fly LC left click on APU button to turn off LC Left Click on APU cover to close Right of dash CMWS Power Switch to on same location CMWS Flare switch to armed same location CMWS operation switch to bypassed left click MFD WPN button (Bottom left) left click BORESIGHT Top centre of Dash Look at concentric circles through IHADSS Move your head until circles are concentric and reticule in eyepiece aligns with centre circle When aligned press Boresight Polarity BS on left side of MFD (or bind Boresight Polarity BS to a key) Right of dash uncage Artificial Horizon by scrolling mouse wheel until red bar disappears and align with "horizon" INS(?) alignment is automatic, however you still need to check. left click on TSD bottom row of MFD buttons left click on UTIL top row of MFD buttons check POSITION CONFIDENCE, INU1 and INU2 should be green, if not wait before moving. Link to comment Share on other sites More sharing options...
Recommended Posts