Zeno~SPARTA~ Posted April 20, 2022 Share Posted April 20, 2022 Given that we spend extra money for clicky cockpits, I think its a shame to not know where everything is. A great way to familiarize yourself with a cockpit is to go through a start up procedure with the aircraft in a Cold and Dark state. Here is the Mirage startup with using the fast INS alignment mode (using stored heading), the long mode takes about 8 minutes and is not covered here. Right Dashboard Battery On Switch (above annunciators) RC Fuel cut off cover and switch on RC Engine Fuel Right Boost Pump Switch on RC Engine Fuel Left Boost Pump Switch on RC Engine Start Switch Cover Open RC Engine Start Switch press When Engine reaches 11% Push throttle forward then pull back, this will allow start up to proceed. Front Dash HUD Power Switch Front screen TD.F right click to turn on RC EW Mode selector Switch right click once RC BR, RWR, D2M, decoy release mode switch, Decoy programme knob, right click once RC Radar IFF Power switch to Sect RC Back up ADI Right Click RC Pitot Heat Cover right click RC Audio Warning Switch right click RC Emergency Backup Hydraulic Switch right click Front dash top Left Audio Warning Reset button left click RC INS mode Selector right click to STH (rotary knob) RC under rotary knob (INS parameter selector) green and red lamp/switch (VAL Validate) left click RC INS operational mode (right of INS Mode Selector) left click to STS RC 2 rows of LCDs above num pad, note 100 will count down to 0 On 0 RC INS Mode Selector right click to NAV and right click INS operational mode to N LC Radar Power right click to Warm Up LC VHF mode right click to FF LC UHF mode right click to ON Link to comment Share on other sites More sharing options...
Recommended Posts